|
Tractor Talk Discussion Board |
Re: Hay Mower, Bar Cutter Replacement Question?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rod (NH) on May 20, 2002 at 19:43:08 from (207.3.148.150):
In Reply to: Hay Mower, Bar Cutter Replacement Question? posted by BlueLite on May 20, 2002 at 18:34:28:
Hi BlueLite, My 5 ft AC sickle mower indicates that those hold down fingers, called knife clips, should have a slight clearance with the knife sections..."thickness of a post card" is called for. You adjust by bending the clips as required. I would assume this to be a pretty universal thing. My mower is vintage 1942. I don't think any hardfacing is called for. I lube my bar and knife sections with motor oil every so often as the manual calls for. Other people don't bother to do that I understand. Rod
Follow Ups:
| Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We've kept the same low rate for six years. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ] |
Home
| Tractor Manuals
| Tractor Parts
| Forums
Copyright © 1997-2012 Yesterday's Tractor Co. - A Washington State Corporation
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters |
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you use antique tractors, collect antique tractors, or just enjoy looking at antique tractors, welcome to our site! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 antique tractor forums, show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
|
|
