Posted by Tom Fischer on January 12, 2013 at 11:29:47 from (71.53.27.15):
In Reply to: Ford 601 + rear blade posted by Tom Fischer on January 12, 2013 at 05:03:31:
Thanks for all the replies.
Three point hitch setup is definitely NOT OEM. The tractor was originally owned by the Country DOT, had a side mower (sickle bar), mowing hillsides. Second owner just used it for pulling a large old reel mower. I'm the third owner. Good news is that the engine doesn't burn a drop of oil (never had a plow on it).
Bad news is that bottom hitch bars are NOT Ford. Measure 32" long center hole to center hole. With the bottom hitch bars horizon, they are about 5" past the rear tires. 6' blade should be able to swing around, maybe the 7' also if it is offset.
Lots of good info here. thanks for any more comments.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
