Posted by H2OK9 on October 17, 2012 at 17:44:53 from (71.50.17.172):
In Reply to: filling bottle jacks posted by caterpillar guy on October 17, 2012 at 17:29:42:
With the jack sitting upright (never fill a bottle jack while laying on its side) on its base and the ram fully retracted, (all the way down) remove the fill plug. fill the jack with hydraulic jack oil. I found the easiest way to do this is fill a squirt oil can full of fluid and use this to fill the jack. after the jack is full to fill hole, open the valve and pump the jack slowly for 10 to 20 strokes on the plunger. (this will help bleed the air if jack was sitting on its side or empty). recheck the oil level, and making sure it isn't overfilled, replace the plug. If the seals and cups are in good shape, the jack should be ready for use.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
