I disagree on the x-ray/ultrasound to a degree. No NDT process is a catch-all. Linear lack of fusion will slide right by an x-ray. There's a newer type of ultrasound that I'm not familiar with that does away with the angle problem. Just like welding, the NDT is only as good as the tech, but is generally the only option for an independent 3rd party.
I agree the more competent welders get the more critical work. There is no test for competence. That takes time.
We could bicker endlessly as far as the tig welder thing goes. They are generally too busy crying or polishing their golden arm to get much done. I don't care for "shoulder to the holder" prima-donna welders. Once orbital or a fusion tig head has been set-up, then yes, that rules.
Lastly, how did you arrive at the conclusion mig welding isn't a qulified procedure? The term "mig" is very vague and we may only be disagreeing on details, but dual shield and pulsed solid wire are used in our R/S-stamp shop for ASME work, and I know pulsed mig is good with NACE too. I do think short-circuit (solid wire) is out, but everything else is ok once all the necessary hoops have been jumped through. Miller's RMD is garnering a lot of attention, but I've never used it. Never used sub arc either.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.