Posted by JOB on August 31, 2012 at 05:50:31 from (74.36.133.90):
In Reply to: Re: Welding aluminum posted by Stick welding on August 30, 2012 at 22:19:28:
Some aluminum wire machines will work better if the base metal is preheated. There are better machines that don't need the base metal preheated. Many years aboard ship we had a Westinghouse power unit that powered a spool gun. The super structure was all aluminum. We could take that spool gun and weld 1/4 inch material to the bulkhead without preheating anything, the welds washed in nice. The bulkheads could have been 3/8" aluminum not sure. Some of the machines I have seen today don't work like that old Westinghouse. Most of our work was Tig. On occasion we would take a Trail blazer miller with a push/pull wire attachment out in the building to weld a piece that was too big or took too much time to take down and bring into the shop. That was welded without preheating.
What I have found when Tig butt welding aluminum, even 1/8" if the aluminum is not hot enough and you are not adding filler rod a crack will start behind the weld. On fillet welds that was not a problem, you add filler rod as you go, or I do.
I have never seen anyone start an arc with a tig machine on aluminum and immediately start applying filler rod, it is always preheated some. It welds better when the aluminum is hot.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
