Posted by jon f mn on August 30, 2012 at 00:12:29 from (66.41.181.115):
In Reply to: Welding aluminum posted by JRSutton on August 28, 2012 at 08:07:50:
Where do you live? If you are near enough I would do it for you. You can run al. wire through a reg mig gun but it sucks. You need 100% argon gas to do it and it works better with harder wire like 5356. As said either a push/pull gun or spool gun works best because the wire is so soft it is hard to get it to feed. You can use stick too, but again it's tuff, especially on thin stuff. You are better off to find someone who has the right equipment and get it done right. The proper equipment is faily expensive partially because it takes more power for aluminum because the heat spreads and disapates so fast. On my miller with the spoolgun I almost never use high range for steel but almost never use low range for aluminum.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
