Posted by john *.?-!.* cub owner on August 28, 2012 at 20:55:42 from (69.179.140.162):
I had to replace a broken hinge on the ramp for my handicap scooter carrier. I have a small wire feed welder, but it si such a piece of cheap junk that I still use my old Lincoln when possible.. I was using some 3/32 rods (6011) from K&T, and stopped to do some alignment and put in a new rod, and could not strike an arc. No spark no nothing, just as if I had a stick in the older. Could not get anything striking the rod directly on the ground clamp. Checked the welder switch, and everything else I could think of, then finally tried another rod. All was ok. Thinking it might have the coating over the endI ground it off some on the end, but still no go. Looked it over real close, and no metal showing on the end. Finally ended up grinding off nearly half an inch to get to metal.
This post was edited by john *.?-!.* cub owner at 20:57:11 08/28/12.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
