|
Tool Talk Discussion Board |
Re: Wood stove in the workshop?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scott on December 23, 2003 at 17:09:03 from (206.9.216.37):
In Reply to: Wood stove in the workshop? posted by Terry on December 23, 2003 at 10:01:53:
I have a 20'x40'x 14ft ceiling, well insulated shop that I heat with a 26" 100 year old parlor stove. I bought a through the roof stainless simpson duravent chimney kit that cost around 375 bucks complete. It takes about 45 min, to raise the temp from 40 to 80 degrees. I use 2 ceiling fans to move air around and it gets so hot somtimes that I have to open the walk in door to cool it down. My insurance inspecter oked it as long as I used the properly installed chimney system and proper clearences from combustables and no barrel stoves. Make sure you use dry wood and periodically inspect and clean the chimney. Wood makes a nice cheap heat source if used properly but it is not push button and requires commen sense to safely use.
Follow Ups:
|
Discount Prices for Parts! You can help support this extensive website by purchasing your tractor parts, manuals and merchandise from our [ Antique Tractor Store ] or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
|
Home
| Manuals
| Parts
| 12-Volt Kits
| Carburetors
| Radiators
| Engine Kits
| Videos
| Books
Copyright © 1997-2008 Yesterday's Tractor Co. - A Washington State Corporation
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
|
|
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you use antique tractors, collect antique tractors, or just enjoy looking at antique tractors, welcome to our site! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 antique tractor forums, show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
|
|
