Posted by JOB on December 24, 2011 at 16:38:29 from (74.36.132.249):
In Reply to: Re: Wisconsin question posted by greygoat on December 24, 2011 at 13:51:29:
Thanks greygoat, what you said is what I thought also. Another engine guy said to buy after market pistons and just replace the two bad ones. My two bad pistons show wear above the top ring lance on the side of the piston that faces the valley. I was told that might have been caused from running too lean. This engine was used on a machine than would crank up and move into position and then shut the engine off. It might have taken ten to twenty minutes to position the machine. So this machine never ran very long at any one time. I call it a machine but it was actually a ramp to unload cars from rail cars. When the valves were removed from the block the intake ports were almost plugged with carbon right below the valve head. I wonder if that was caused from short run times?
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
