|
Antique Tractor Paint and Bodywork |
Re: What Does DA Stand for on DA Sander/Polisher?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jerry b on December 14, 2001 at 08:53:04 from (162.114.24.120):
In Reply to: What Does DA Stand for on DA Sander/Polisher? posted by Bob K on December 13, 2001 at 11:22:25:
I think a word or two of encouragement is called for here. Lacking tools, you can get that champagne look you are wanting by hand, but it just takes longer. Keep in mind that the final sanding on any paint job is by hand. After the DA's, long boards, orbitals ect, the final sanding of the primer prior to painting is done by hand using quality wet/dry paper and a sanding block. I used 240 grit or finer for final sanding. Some will shudder at the thought of using anything coarser than 360, but keep in mind that if you put enough paint on the surface, then color sand and buff well you will not see the scratches. The slightly deeper scratches of 240-260 grit will hold more paint and hold it better than the shallow scratches of 360 grit and the paint will stick tighter and be less likely to come off. There is a guy near here who makes a living as a "body man". He will paint an entire car using 2 quarts of paint and it shines pretty good. I asked him how he was able to make it shine with so little paint and not have the sanding scratches show. He said "What sanding scratches?. There will be no scratches if you don't sand". oooookaaaaayyyy.............. Within a year the paint is peeling from the car but there is no warrantee. Here is something I knew all along but I really got the message quiet by accident a few years ago. I was painting my fathers Eldorado. The body work was completed. It was all primed out, hand sanded, masked off and I had it pulled outside in the sun as I swept and cleaned the floor in preparation for painting the next morning. I had tacked it down once and thought it looked very good and figured once more prior to painting would be fine. I left to go buy the paint and let the car set in the sun. About the time I got to the store it came a "toad strangling" rain storm that lasted about 20 minutes. Big ol' silver looking drops that hit hard and dug holes in the ground! I thought the paper on the Caddy would be ripped and ruined. Upon returning about an hour and a half later, I found everything looked fine. The rain had beaten the sanding sludge and dirt from the car and the sun had dried off the paper. All I had to do was dry around all the edges. As it turned out there was only 1 speck of dirt in the paint. Not bad for painting outside on a carport. CLEAN, CLEAN, CLEAN, CLEAN... you get the idea.
Follow Ups:
| Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We've kept the same low rate for six years. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ] |
Home
| Tractor Manuals
| Tractor Parts
| Forums
Copyright © 1997-2012 Yesterday's Tractor Co. - A Washington State Corporation All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters |
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you use antique tractors, collect antique tractors, or just enjoy looking at antique tractors, welcome to our site! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 antique tractor forums, show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
|
|