Posted by TheOldHokie on February 10, 2013 at 03:21:42 from (108.22.202.212):
In Reply to: old your opinion posted by POPGUN on February 09, 2013 at 15:38:28:
Quoting Removed, click Modern View to see
I have an old block and I intentionally snapped a few studs off in it to try different techniques:
You can easily to set the block on the table of a large drill press or mill. From there drilling/milling the bolt out is darn near trivial.
I had high hopes for the "heat it and blow it out" with a cutting torch idea. My torch skills must need honing because I got the bolt out along with quite a bit of the bolt hole wall :oops:
Didn't have time to try the welded nut idea but I will when i get a chance. My welding skills are about on par with my cutting torch skills and all I have is an old Lincoln stick welder. I wouldn't even think about going after a bolt below the surface. I'd weld it to the block for sure.Film at 11.....
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
