STUCK ENGINE I have an old impact chisel tool. years ago I fabricated a round flat piece of 3/8" plate and welded a big deep nut in the middle of it. When I get a stuck engine I take the head off and pour diesel fuel on top of the pistons and them take the impact with a flat ended tool in it and sit my fabricated tool on top of the piston and let it hammer. I've never failed to loosen the worst stuck and rusted engine with this thing. The crank won't move with the first two or three but when that fourth one breaks loose it will usually begin to move the piston down. Believe it or not it will usually loosen the stuck rings too because they are what is stuck to the cylinder wall and the vibration will wiggle the loose most of the time. You can tell if the rings are free by looking down beside the piston at where the end gap is and wiggling the piston back and forth to see if the rings move. Zane
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
