Posted by JMOR on October 14, 2012 at 07:25:15 from (72.181.173.171):
In Reply to: cam lobe height posted by TOM N MS on October 13, 2012 at 13:09:48:
TheOldHokie said: (quoted from post at 07:33:05 10/14/12)
JMOR said: (quoted from post at 23:16:17 10/13/12)
JCinKY said: (quoted from post at 23:08:49 10/13/12) http://www.oldfordtractors.com/oftspecs.htm
Not sure if it's 100%, but seemed close enough to rebuild my engine. The "original" copy was soaked in oil in the tool box so it took me awhile to find it again.
Cool! I looked there, but obviously not close enough! Thanks.
Careful - look at the column dividers in that table. Those numbers are only for the OHV engines - not the L-head.
TOH
Clearly still not looking close enough! :cry:
And if trying to check cam for wear on those OHV engines, one would need to measure at the valve, not the cam lobes, unless he knew the rocker arm ratio, since the chart gives valve lift. That would be obvious to TOH, but maybe not for the world wide population. :wink:
This post was edited by JMOR at 08:03:10 10/14/12.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
