Defndr---for starters, long linkage rod goes to long governor arm, short linkage rod from carb to short arm of governor....long to long, short to short.
First, unhook the LONG linkage rod at one end, place your throttle arm in the "idle" position. Now adjust the LONG linkage rod so that it just fits snuggly between the throttle linkage and the governor arm. Low rpm is now set.
I assume you have a late model 8N with tachometer/hour meter as you seem to know what the rpms are.
Look at your governor, there is a "stop nut" at the bottom of the arm that allows you to "set" the high end at 2200 RPM"s. This nut simply screws in and out and when adjusted correctly will not allow the rpm"s to exceed the set limit.
Next, start the tractor, and increase the throttle until your rpm"s arrive at the 2200 rpm level and SET the stop nut at this point.
You now should be very close to finish settings, other than possible carb adjustment.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
