Posted by Bruce (VA) on November 04, 2009 at 10:09:42 from (24.125.26.10):
In Reply to: Re: Radiator posted by G6 at Snook, TX on November 04, 2009 at 09:59:30:
After you get the 4 bolts off of the dash, remove the wire going to the head lights. Then, w/ the gas off, unscrew the fuel line at the carb. If the tank is full, you should drain the gas out. Then, get a couple of saw horses to put the hood on when you get it off. Remove the two bolts at the bottom of the dog legs. They are attached to the motor mount. The grill is held in place by two hinges at the top & the dog legs at the bottom. After the dog leg bolts are out, the grill will fall out.....usually on your foot. Pull the hood forward about an inch, then up to clear the radiator neck. It should be easy after that. A helper makes it much easier. The radiator is held in place by the top hose & two carriage bolts at the bottom. Remove the nuts off of the bolts; the radiator will swing out (not lift off) like a door. When you put it back together, make sure you place the top radiator hose at the same position it was on the top inlet; if you push it up too far, it will pull the radiator back & you will never get the hood on. Don’t ask………..
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We've kept the same low rate for six years. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you use antique tractors, collect antique tractors, or just enjoy looking at antique tractors, welcome to our site! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 antique tractor forums, show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
