Posted by tromine on July 15, 2012 at 18:02:57 from (173.25.89.235):
In Reply to: Low power 605 posted by toolz on July 14, 2012 at 22:17:06:
toolz, watched you pull last night. I thought you were in 3rd! Should've done much better than that in 2nd. I never messed/checked with timing at all. When I got it, put a new set of points in it and ran it. Ran 3000 plus most of the time trying to keep up with 800's but with stock cam, extra rpm didn't do much for power or torque. In my opinion only, with that model E regulator and impco 200,fuel shouldn't be a problem. I haven't really studied your plumbing up close. When it was in my tractor I was using a forklift LP tank. I was told there were two sizes of valves with regard to gpm they would flow. I think they were like 1.9 and 3.8 or somehting close to that. My tank had the 3.8 gpm. I assume your using the stock valving and lines on your GVI, I assume those valves flow enough?? I'm not an LP expert. I don't know if some guys run 800 pullers with the stock valves/lines on the MM tractors.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
