Posted by Clifton1979 on September 16, 2012 at 14:15:57 from (220.127.116.11):
I have a 1974 Massey Ferguson 1085 that is having some hydraulic issues. The three point will come all the way up when I start the tractor, no matter what position the controls are in. It looks like the controls are not set right but has been apart by the previous owner and do not know how they go back together correctly. If someone has a picture of the linkage on the three point controls that would be a great help. The three point has all the way up or all the way down and to get it down you have to run it the control all the way forward indstead of backward, something has got to be out of wack,that is why I am wanting pictures of the linkage to see what they have wrong. I have ordered a service manual but it is not here yet. The PTO always turns but I figure that is the PTO brake bad and will replace it when I go into the transmission, the PTO takes for ever to lock up as well. When I put a brush hog behind it, it will take about 10 seconds before it loads the motor. I was told these have two pumps, one for the 3 point and one for the auxilliary hydrualics. The Auxilliary has between 2200 and 2500 PSI which I understand is good. Any help would be great. Thanks!!!
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.