Posted by DavidP,South Wales on February 08, 2010 at 01:20:20 from (78.150.39.152):
In Reply to: Re: MF250 stuck in reverse posted by WorldWideTractorParts on February 07, 2010 at 19:40:02:
Hi, WWTP has given the instruction to reset the selector position which should rectify the problem. It may be necessary to remove the filler plug extension if fitted. Check the gear lever for excess wear by turning it back and forth. Also check how much up and down is present. The elongated pivot hole in the gear lever will wear as will the pin that secures it. I have replaced several gear levers and pins on 250's. If this excess movement is present it would be advisable to rectify it ASAP as it will happen again. The chances of a repeat can be reduced slightly by pushing down on the gearlever slightly at each change and making a positive movement from your selected gear into neutral, then across (if necessary) and then into next gear. Try to make it a 'square' change rather than a diagonal one. DavidP
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We've kept the same low rate for six years. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you use antique tractors, collect antique tractors, or just enjoy looking at antique tractors, welcome to our site! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 antique tractor forums, show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
