Posted by Roy Suomi on November 06, 2012 at 16:22:45 from (220.127.116.11):
In Reply to: jd 450 posted by reverendjdb on November 06, 2012 at 08:22:44:
Okee-Dokey... Here we go..Install a gauge into hlr test port..shift 4 speed trans between 3rd and 4th..There is a narrow neutral in there.. Lock down brake pedal.. Remove both floorboards. Under each floorboard you will find large rubber plugs in the clutch housing.. The one on the right is the pressure regulating valve.. The one on the left is the speed of shift/ pressure adjustment..The clutch pedal "free-play" should be 3 and 3/4" from top of pedal to the point the clutch fingers contact the throw-out bearing.. This adjustment is accomplished from the vertical bolt next to the clutch pedal.. Start the machine with brake locked down and 4 speed in neutral..HLR in neutral.. Run the engine at about 1000 to 1200 rpms.. Watch the gauge when shifting the HLR lever in all 3 ranges.. Are all ranges about the same pressures?? [ 150-165 lbs]If so , take a ratchet with a 1/2" deep socket and short extension into the hole on the left [ by clutch pedal]..Watch the gauge while turning the nut down [clockwise].. Is the pressure going up ?? If so.... Run it up to the maximum pressure where the gauge just starts to drop off.. If you just touch the pedal and the gauge goes up about 5 lbs, you're real close to that sweet spot you need to be at..If the high to reverse shift is too quick, turn that adjustment slightly clockwise.. By the same token, you don"t want that shift too slow.. This causes slippage and transmission heat..When you make the high to reverse shift , the machine should just pull you off the seatback at wide open throttle in 2nd gear without touching the clutch pedal during shift..The plug under your right foot is the pressure adjustment if you cannot get 150-165 lbs..I shim this valve with pennies... Yup.. Each penny is good for about 15 lbs..I grease them into the cap of the plug..Let me know if any other help is needed..If no pressure increse is noted..... The rollpin at the bottom of the vertical speed if shift adjustment might have broken.. Roy
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.