Posted by NoDakInMN on September 27, 2012 at 19:18:17 from (76.10.68.191):
In Reply to: rpm speed posted by gary in neb. on September 26, 2012 at 06:43:33:
"clean sine wave power"? Since all alternating power has a "sine wave" I'm somewhat unclear by what you mean as the sine wave is tied to the hertz or cycles of the power. 60 hz is 60 hz. What I suspect you are having problems with is the voltage supply. A variation of + or - 10% of design voltage will create havoc with electically powered devices be it motors or electronics. If you overload your generator you will reduce the voltage, possibly to the point of exceeding the 10% limit. This can happen when the inrush current of certain things starting creates more draw then the generator can supply. Some people will load up their generators with steady draws near the maximum output of the generator and then when a fridge, freezer or some other device that has a high inrush current comes on, then the generator will overload and the volts will drop.
When I use mine, I unplug my freezers and water heater as well as any other electric heating device. I then monitor the amp draw and leave ample supply for my fridge to come on. Then from time to time I shut down all I have connected to it and then let the freezers and such run by themselves as needed.
Too many people just plug things in until their generator bogs down and back it off a bit. But you need to monitor your amerage based on the wattage output of your generator and then you will have stable source of power.
Oh, and make sure that you have opened your main disconnect on your panel before running your generator as it will backfeed down the line otherwise and create added draw on you generator as well as making it very dangerous for the linemen trying to restore power.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
