I FINALLY FOUND A SAW SET, A TOOTH SETTER. mY TEETH WERE ALL BUT INLINE. i CUT BY MYSELF, AND HAVE NO OFF BEARER, SO THE TEETH GET STRAIGHTENED EVENTUALLY. aFTER SETTING, i JUST FILE EACH INDIVIDUAL TOOTH IN A COMFORTABLE ANGLE WITH THE END OF THE FILE GOING OUT IN THE DIRECTION THE TOOTH IS ANGLED. aFTER FILEING THE RUST OFF, i THEN TAKE THE FILE, A FLAT ONE, AND RUN IT OUT FROM THE OTHER SIDE OF THE BLADE STRAIGHT OUT IN LINE WITH THE BLADE AND BRING IT OUT. kINDA LIKE FILEING THE BACK SIDES OF SICKLE MOWER SECTIONS. tHIS TAKES THE WIRE EDGE OFF. i DO ALL ON ONE SIDE, THEN DO THE OTHER SIDE THE SAME WAY. if ANYBODY EVER NEEDS A HAMMERMILL BELT. LOOK AROUND FOR USED ROUND BAILER BELTING. i HAVE 2 FULL LENGTHS THAT MAKES A long BELT AROUND 50FT. but i NOTICE THAT THE SAW RUNS SMOOTHER WITH A LONG BELT. iM USEING A SHORT ONE TODAY AS IVE MOVED THE SAW FROM ITS ACCOSTOMED PLACE AFTER 30YRS SO AS TO CUT GREEN WOOD AND PUT IT IN A PILE OUTSIDE THE WOOD SHED. wHEN IM DONE, AND THAT OUGHT TO BE AROUND 3 RICKS, iLL REMOVE THE SAW BACK SO THAT THE BLADE STICKS INSIDE THE WOOD SHED, AND RESET IT THERE TO CUT A BIG OLE TREE THATS BEEN WIND BLOWN OVER FOR A YEAR AND GOOD AND DRY.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.