Posted by Skyhighballoon(MO) on October 18, 2012 at 07:02:24 from (135.245.8.6):
In Reply to: Gleaner E rattle chain posted by orangepower on October 18, 2012 at 02:52:12:
If you have the header, off the raddle chain isn't too hard to get at via an access door below the feederhouse (when the feeder house is in the raised position). On an Gleaner E the raddle design uses implement chain and wooden slats. EIII is the same (I have one).
If you loosen the chain adjusters and can use an implement chain tool to take links apart on each side then it's not to difficult to get out at that point I would think. The weak link is the wooden slats, corn in particular is hard on them and you'll find most running E's with some missing wooden slats from breaking. They were riveted in at the factory so while you can make new slats (not sure if AGCO still sells them), it's more of a pain to rivet them back in while the raddle is still in the machine. I don't know if AGCO still sells whole new raddle chains. I'm sure they'd be pricy if they did.
On the K, they went to a CA550 roller chain raddle and thus it uses different sprockets. You can upgrade the E I believe to the newer K sprockets and buy a K raddle to replace it but you'll probably spend $1K for the new roller chain raddle and sprockets. The sprockets I believe would be a bit of a project to replace. Abeline Machine sells raddle's for K's, about $440 plus shipping. Mike
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
