Posted by joe csuti on December 08, 2012 at 04:18:49 from (70.111.201.4):
In Reply to: Re: 516 H posted by Old Roy on December 07, 2012 at 18:34:41:
Goto link below,click on toro logo,enter 06-48BC01 in mod search on left side of pg,this is a complete assembly drawing/parts list for blade.
In pic you posted the orig handle is laying against blade,Thin rod from squeeze grip on handle went to a bellcrank mounted on angle bracket by handle mounting/pivot bolt,from bellcrank another thin rod ran to latch plunger to hold blade in position after changeing angle,also many of the pre C/early series C tractors used a chain rather than a bar to connect blade to lift handle arm(I have both styles),the chain/bar usually connected to center/intermost hole on rock shaft arm closet to lift handle
The usual method to install blade on tractor is remove pivot bolt for handle,remove or lay handle on ground,drive tractor over blade frame,slip cross shaft on A frame into quick attach on axle & lock,connect arm/chain to lift handle arm,reinstall arm for angle adj on blade.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
