Thanks for the reply Rich. As you mentioned, I"m certain everything needs to be calibrated etc. I know I"ve completely gone through the injectors a number of times questioning if the spray pattern was right and if they are opening properly. Delivery valves and injectors for cylinders 1&2 seem to be fine, but number 3 just doesn"t seem like it sprays anything like it is supposed to. Even with a new injector tip. If I remove the number 3 line from the delivery valve on the injector pump it doesn"t seem to be producing the solid stream of fuel like the others either. When I went through the pump I didn"t notice anything other than some pits on the cam lobes (from metal debris from cracked springs?) and some corrosion to the front bearings that the cam shaft rides on. With that being said and the fact that all three plungers, barrels, and springs are new what would your best guess be? One thing for sure is "internal phase timing" is waaay outside my area of expertise. Any and all ideas are most certainly welcome and thanks for the info so far.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
