Home | Gallery | Forum | Store Ford N-Club : 8N - 9N - 2N
red and gray ford 8NFord 8N - 9N - 2N Tractors Research & Restoration Headquarters
Antique Tractors - Ford 8N, 9N and 2N
Shopping
Ford 8N Parts
Ford 9N, 2N Parts
Manuals: Ford 8N
Manuals: Ford 9N
Manuals: Ford 2N

Pictures
Master List
Ford 8N Photos
Ford 9N Photos
Ford 2N Photos
Archived Ads

Community
8N Discussions
8N Forum Archives
Classifieds: 8N
Classifieds: 9N
Classifieds: 2N

Information
History
Specifications
Implements
Serial Numbers
Resources
Clubs & Magazines
Funk Conversions
Tractor Values
Tune-Up Specs
Ford 8N Registry

Articles
Carb Overhaul
Engine Overhaul
N-Series Fluids
Ferguson System
9N Lives Again
8N Differences
12-Volt Conversions
Mom Drove the 8N
8N and the Fox
Plow Trenching
75 Tips
More Articles...


Ford 9N, 2N, 8N Factory Specifications

Ford 9N & 2NFord 8N
Engine Four cylinder with an L-head; 3.187 x 3.75 inch bore and stroke; compression ration 6 to 1;piston displacement 120 cubic inches. Four cylinder with an L-head; 3.187 x 3.75 inch bore and stroke; compression ration 6 to 1;piston displacement 120 cubic inches.
Horsepower Belt horsepower rate - 20.29, maximum - 23.87. The drawbar as having a two-plow pulling capacity. Belt horsepower rate - 23.22, maximum - 27.32. The drawbar as having a two-plow pulling capacity.
Torque 84 foot-pounds at 1500 rpm. 92 foot-pounds at 1500 rpm.
Ignition Direct-drive front-mounted distributor with coil, automatic spark advance. Direct-drive side-mounted distributor with coil, automatic spark advance.
Generator 3-Brush, 6-Volt 2-Brush, 6-Volt
Starter 6-Volt automobile starter with safety switch integrated with gearshift. Same
Cooling Water pump circulated water through tube and fin radiator; system was pressurized; 6-blade fan with 16 inch belt; held 12 quarts water. Basically the same but with 4-blade fan.
Carburetor Plain tube with updraft. Basically the same
Clutch Single 9-inch plate, plate pressure increased as engine speed increased. Same.
Transmission Three speeds forward and one reverse; sliding gear. Four speeds forward and one reverse.
Steering Steel steering wheel covered with rubber, 18 inches diameter; bevel pinion and twin bevel sectors controlled both front wheels independently. Automobile type; Ball-nut gear.
PTO (Power Take Off) Shaft 1.125 inch spline; shaft had a speed of 545 rpm at an engine speed of 1500 rpm. Same.
Hydraulics 4-cylinder pump with both automatic and manual valve control; control lever located at the right of the operator. Four pistons; internaly mounted; max pressure 1500 psi.
Weight Approximately 2340 pounds with no liquid in tires. About the same
Color Entire tractor (including wheels) was Dark Gray Sheetmetal (fenders, hood, etc) color gray, body (castings) color red.

SHOP  FOR  PARTS SHOP  FOR  MANUALS
Fast Shipping!  Most of our stocked parts ship within 24 hours (M-Th). We have the parts you need to repair your tractor - the right parts. Our fast shipping, low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]