Posted by GT65 on January 03, 2013 at 03:13:42 from (50.48.63.14):
In Reply to: Grader Blade Edge posted by Tom Bond on January 02, 2013 at 17:15:59:
It could rip the blacktop up if you were close to the edge or had some potholes to start with. Tom is there no way to weld 2 or 3 pieces of short steel pipe on the back of your blade. You know so you could run some threaded rod through it and have the lower end welded on to a steel dish to make your own adjustable shoe. Come on Tom I've seen your work before.I bet you could adjust it to where your hardly leaving any ice behind then double or triple nut the rod,paint it up and make it look like a factory application! Seriously this time of the year if you don't scrape it way down(I'm afraid using that pvc will leave too much behind!) it could be worst then if you did nothing at all and we don't need anyone slipping and getting hurt! Good Luck! GT65
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
