Posted by 200cs on November 04, 2009 at 16:33:54 from (173.64.212.27):
Hi all, I recently picked up my brand new to me One Arm and I am getting my goodies together to build brackets with help from a friend who is a machinest. So here goes...
I have a 1972 Ford 3000 and I have the correct loader for that tractor according to the previous owner but no brackets. No problem says my machinest friend, we can build them. So we will get started. I would like to have a general dimension that is a correct starting point.
I would like to know the measurement from the top aft bolt of the hip bracket to the "nub" the loader sits in. I would like to know its measurement from the center of the bolt hole to the center of the nub measuring in a strait line aft and then from that point, measure strait up from the bolt line center to the center of the nub. This will give me two sides of the triangle and a good starting point. The other brackets can be fabbed where ever the loader falls in.
This post was edited by 200cs at 16:34:26 11/04/09.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We've kept the same low rate for six years. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you use antique tractors, collect antique tractors, or just enjoy looking at antique tractors, welcome to our site! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 antique tractor forums, show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
