Posted by JasonKS on July 20, 2012 at 06:09:18 from (147.182.5.150):
In Reply to: TO-30 Wiring question posted by Richard L on July 17, 2012 at 07:03:11:
I just found this article in the "Articles" section of this site.
http://www.ytmag.com/articles/artint195.htm
You are correct. Prong 2 should be going to the BATT terminal on the alternator. However, if I'm reading this right, Prong 1 should be going to the "start" position on the key ignition, not the "off" position. Is this correct?
Right now, the wiring has been electrical taped, giving the impression that the wires coming out of the prongs are spliced into the other wire from the post to the Off position. I will unwrap this wiring this weekend and figure out what's going on. Thanks for your help.
This post was edited by JasonKS at 07:11:17 07/20/12.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
