From how you describe it, you have been pulling from the top link rocker and not the drawbar. Any load should be taken on the lower link arms or a drawbar slung underneath. You should never pull from the top link connection, besides breaking it out, it is very dangerous because should the tractor grip it will lift the front wheels off the floor and turn upside down and crush the operator. It is set too high for pulling and they warn about this in the Instruction Book. The Control Valve will hold in position even without the Control Fork attached until it gets to near the ends of the valve itself and as it is shaped it will "squirt" the Control Valve out, but it will hold it in place if you need to. If the Control Fork is out of alignment have you tried adjusting the Control Lever Quadrant to overcome this?.The parts you need for the Top Link Connection are available again now.If you want to know how to reset the Control Lever, email me at:- fergusontractors@tiscali.co.uk tell me what you need and I will send it..John
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We've kept the same low rate for six years. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you use antique tractors, collect antique tractors, or just enjoy looking at antique tractors, welcome to our site! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 antique tractor forums, show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
