Both starters have 9 teeth on the gear. The new starter does not have anything stamped on the body. I checked the flywheel teeth more closely. There was an area on the flywheel where there was significantly more wear on a few teeth. A few inches away from that areathere was a tooth that was broken in half. I will measure the starter diameter later on.
In regards to the fix, i understand what you are saying in regards to the bridge. After closer inspection there is a hairline crack above the the upper hole also. What if i hade a plate made up the fit into the cutout area where the starter mounts?. This plate would have the starter hole and mounting bolts cutout but would also have the two bolts in that area that are used to bolt the block and tranny together also cutout. That way these two aditional bolts would help support the entire area. The only issue would be the plate thickness would affect how far the starter goes into the block. Would this be possible with a thin enough plate?
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
