[quote="John(UK)"](quoted from post at 16:05:18 11/12/12) If you have fitted a new or different starter, this could be the problem. On the original starter there was a lip all the way around the face where it sits in the hole for the starter in the block. If this lip is wrong dimensions, it would cause your problem, compare it with the original starter.
With the starter not mounting correctly, it will not mate up with the block properly and will be mounted at an angle instead of square-on to the Block. The lip was to provide support for the starter and take the load off the bolts.It would also be the cause of damage to the teeth on the Ring Gear...John(UK)....fergusontractors@hotmail.com[/quote
Here are a couple of pictures. The new starter does have the lip that you mentioned on it although it appears to be a little more pronounced than the original. I really dont know much about tractors but the picture of the flywheel shows wear on the front of every tooth, there doesnt weem to be any wear between the teeth. Is this normal? The third picture is of the new starter teeth that were broken.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
