(800) 853-2651
SHOP NOW

OT: 2000 Impala Rotor

C

Christos

Member
I was trying to replace my caliper assembly last night and ran into a snag. The front passenger rotor wson't slide off. I've tried penetrating oil and rapping with a hammer...something is causing it to stick to the hub. I can get it to wobble some but nothing beyond a centimeter or so.

Any ideas on how to remove it? I know it should slide off but its just not,

Christo
 
Well if your anywhere Near Pa. You"ll end up
needed Heat.. Such as Torch.. Start with alittle
& hopefully you won"t end up needing alott.
 
Silly question, maybe; but why do you need to take the rotor off if you are only changing the caliper??

Aside from that, a lot of rotors do not have much clearance from the hub, and they rust in place. You might have to get out your sawzall.
 
If you need to have your rotor "turned" on a lathe, consider leaving them on and find a shop that turns them while they are on. I had mine turned by such a shop and will NEVER consider letting anyone do it any other way again. They are perfect!
 
You must log in or register to reply here.

Similar threads

F
Any ideas?
Replies
8
Views
407
Fred Werring
F
J
1949 Model A Help
Replies
3
Views
244
JDTWOPOPPER13
J
J
Need Help on a 2000 F350????
Replies
11
Views
2K
Cameano
C
W
The Water Buffalo and too much oil !
Replies
0
Views
10K
Aaron-HT
A
J
Aux Valves questions
Replies
2
Views
518
JAsher452x
J
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top