1240 Massey Ferguson


does anyone know were to get a free parts break down of the injector pump for this tractor? Tractor runs fine but is hard to start, I have determined fuel is not being turned back on after tractor is shot off, but the electric kill selinoid is working properly. any advice or parts break down would be appreciated.
 
I had the same problem and was not able to find any info online. However, there is a small square door on the the side of the pump. Remove it and the rack that the electric solenoid is moving back and forth is sticking.Remove the pump by removing the 4 bolts on top and then remove 3 springs with a pair of needle node pliers. Once you have that removed, the whole pump will come out. You will see that the rack is hung up. The solenoid is not strong enough to push it back and forth. At that point I discovered a burr on the shaft of the plunger. I cleaned it off, polished with very fine sand paper and re assembled. Make sure you pay attention to how you take the pump apart because it is timed. This solved my problem. Hope it help you as well. Or...If you are in Michigan, bring it to me and I will fix it for you.
 
Thanks for your help. The solenoid pushs it in fine its just when the shaft is supposed to come back out, wants to hang up, but it does come back out you just have to crank on it a while.
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top