Spare tire holder

Richard from SE AZ · Nov 19, 2010

It's finished except for paint. That is the spot where I want to mount it. It hangs on the beam with a piece of angle iron.The 4" piece of flat stock goes to the bottom of the channel and I want to bolt it to the channel. I could weld it on but I want to bolt it so I can take it off if I need to.Thanks for the replys.
(more parts and pieces being put to good use)

Mike (WA) · Nov 19, 2010

You won't need very big bolts to hold that on, as it will be held on by its own weight, for the most part. You mentioned 3/4" bolts, but that's way too big IMHO. A couple of 5/16" (or 3/8, at most) would do just fine, and would have no effect on strength of the trailer frame.

Spare tire holder

Richard from SE AZ

Member

Mike (WA)

Well-known Member

Similar threads