(800) 853-2651
SHOP NOW

851 w/no PTO shaft

A

Anonymous-0

Well-known Member
So I'm in the market for an auger. I found what looks like a reasonable deal and told the guy that I needed to see if the output shaft on my Ford 851 matched his auger. So I see what looks like a cap covering the shaft and I try wrenching it off with a channel lock and it won't budge. So after cleaning the caked on dried out dirt, I see that the cap is bolted on. And I guess you know what happened (that I wasn't expecting) and I couldn't get it back in fast enough and lost a sizeable amount of hypoid.

So is there a part that I can buy that replaces the cap and has a shaft sticking out of it? I looked at my 9N and it had a shaft sticking out of it. Any chance I can swap the two so the 851 has an output shaft?
 
There is a shaft assembly with bearing and flange available. Whether or not you have the parts up inside the tractor to accept the shaft is another question. There may be a better answer over on the Ford tractor forum.
 
Thanks PopinJohn, when I pulled that cap off it had a shaft connected to it. The shaft is something like a foot and a half to two feet long with a spline on the far end.I guess it's really more than a cap because it has a bearing in it and the part that slips into the rear end is a sleeve about three inches long.

I took your advice and posted the same thing on the Ford Forum. Thanks again, Ernie
 
You must log in or register to reply here.

Similar threads

F
Ford 851 - Adding a hydraulic Dearborn snow plow...How does the piping work?
Replies
3
Views
465
Fargo
F
jd2cyl1943
John Deere B Pto help ASAP
Replies
4
Views
619
620 John
620 John
F
Rear Axle shims on a Ford 800?
Replies
5
Views
417
F800
F
M
PTO pump question
Replies
4
Views
363
mfbengel
M
W
PTO output shaft sleeve
Replies
2
Views
257
showcrop
showcrop
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top