running rough after rebuild.

trevor patnoad · Aug 29, 2010

I noticed that when I rotate the distributor back it runs better but still misses. am I 1 tooth off? and if so when I pull the distributor should I rotate the shaft toward the rear 1 tooth or toward the front of the tractor 1 tooth? it just has no high revs and is running a little rough at idle( 500 rpm's). any help from you guy's would be great. thank's trevor

Bob · Aug 29, 2010

Trevor, the "N"'s have some design features that are not exactly mainstream for it's era.

WHY not post on the "N"-specific Forum to put your questions in front of the group most familiar with the little quirks of an "N"?
N Board

old · Aug 29, 2010

You have posted this question more then once. What don't you go back and look at what others have said to you??/

SCHMUCK 1 · Aug 30, 2010

#1 cylinder at top-dead center. Install distributor with rotor pointing to #1 spark plug wire. Distributor should have room to be rotated both clockwise and counter clockwise as needed. This is assuming the cap is wired correctly and the #1 cylinder is on the compression stroke, not exhaust stroke.

running rough after rebuild.

trevor patnoad

Member

Bob

Well-known Member

old

Well-known Member

SCHMUCK 1

Member

Similar threads