fan belt replacment

Anonymous-0 · Aug 5, 2010

Can any of you fine gentleman tell me how hard it is to change a fan belt on a Ford 2000 3cyl diesel with a front pump and loader? It looks to be a big job, unless I'm overlooking it. Anybody have any experience? Thanks in advance. Mike

souNdguy · Aug 5, 2010

just like the other posters told ya.. you will have to disconnect the pump drive.

soundguy

Anonymous-0 · Aug 5, 2010

they make a v belt that you can take apart,has riverts every inch or two, seen one on a sawmill last week, don't know where you can get them but if I was you Id be asking around, sure would be slick for a set up like you have.

Ultradog MN · Aug 6, 2010

You can unbolt the front pump and pull it forward about an inch so the splined shaft disconnects from the front pulley on the engine. Tie it off with a rope to a rafter in the garage etc and let hang there. No need to take apart any hyd lines. It shouldn't be a bad job other than having to reach in around the loader frame to thread the new belt over the fan etc.

bill mart · Aug 6, 2010

Mcmaster Carr has the adjustable length V-belts. bill m.

Anonymous-0 · Aug 6, 2010

Thanks for the info guys, now which one of you gentleman is going to come over and do it? LOL :>) Thanks Again Mike

buckyfarmer · Aug 6, 2010

Been there done that only takes a couple days of sweat and talkin to yourself about some dumb engineering designer

fan belt replacment

Anonymous-0

Well-known Member

souNdguy

Well-known Member

Anonymous-0

Well-known Member

Ultradog MN

Well-known Member

bill mart

Well-known Member

Anonymous-0

Well-known Member

buckyfarmer

Member

Similar threads