(800) 853-2651
SHOP NOW

trying to identify spindle

T

TJC in MN

Member
Hello,
Someday, I might try to put hubs on these spindles, but the person I got them from didn't know what would fit them. I havent had any luck asking what hubs would fit these "almost diamond " shaped spindles, with about 1.5 inches flat on bottom. These were on a homemade wide front end on an allis c, It doesnt look like anyone has painted them, attached is a few pictures.
Thanks alot.
a16780.jpg

a16781.jpg

a16782.jpg
 
Don"t worry about identifying the spindle. What you need to do is measure the diameter of the spindle where both the the inner and outer bearings will set, and then find hubs that will accept those bearings.
 
You must log in or register to reply here.

Similar threads

A
Need advice 2N purchase
2
Replies
27
Views
3K
Caryc
C
P
Hub on cotton wagon
Replies
3
Views
1K
ptbrophy
P
J
Way OT - trying to identify
Replies
13
Views
3K
oldtanker
O
K
Hybrid 601 part number ID desperately needed!!
Replies
5
Views
2K
steamnjn23
S
J
Unusual front end weights! Not (factory) LOL
Replies
7
Views
3K
BCnT
B
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top