reel dimmensions for a IHC grain binder

RayP(MI) · May 31, 2010

Have to cut up some lumber to make replacement parts for an old IHC grain binder. Not able to contact owner for dimmensions - Can anyone help?
Even if I could just gel length of the slats, it would be helpful. Short dimmensions on spreader bars would be helpful too!

big jt · May 31, 2010

Need a little more info.

Width? 6',7', 8', or 10'
PTO or Ground drive? Not sure if this makes a diff on reel but I know it does on the canvas.

If you are talking 10' PTO of course I can help you out. By the way the arms on the reel taper.

RayP(MI) · May 31, 2010

Ground drive, Guessing the cut would be 5 feet. Know it wasn"t very wide compared to my Farmall 200, that I pulled it with. Don"t ask why I owe him some repair parts!

bigjt · May 31, 2010

LOL as to why. That comment pretty much tells me what happened. You aren't the first so don't feel to bad about that. Not likely to be the last either.

All I have are 10' PTO's and if what you are working on is a 5' I am pretty sure stuff off mine won't be much help.

Too bad you can't measure the other ones on the machine coz that truly is the best way to make new. There are angles that are hard to describe without a blueprint or old part.

Maybe someone else out there can be of more assistance.

jt

reel dimmensions for a IHC grain binder

RayP(MI)

Well-known Member

big jt

Well-known Member

RayP(MI)

Well-known Member

bigjt

Member

Similar threads