Pitalplace
Member
I had instructions once on how to level the head on this loader. I can not locate where they were found. No luck with Google. Anyone here have the instructions? Thanks
- Thread starter Pitalplace
- Start date
Allan in NE
Well-known Member
Hi Pard,
Hey, eyeball that lower rear U-iron. Make darned sure it is straight 'cause if it's bent it'll just drive ya crazy tryin' to level that front end out.
Then check it's attaching bolts (boltholes) to the mount to make sure both sides are the same. If one side or the other is forward or back, it will hang on one side up front.
Also, there will be shims at the uprights where they mount in the channel, allowing ya to "tweek" it a bit.
Allan
Hey, eyeball that lower rear U-iron. Make darned sure it is straight 'cause if it's bent it'll just drive ya crazy tryin' to level that front end out.
Then check it's attaching bolts (boltholes) to the mount to make sure both sides are the same. If one side or the other is forward or back, it will hang on one side up front.
Also, there will be shims at the uprights where they mount in the channel, allowing ya to "tweek" it a bit.
Allan
OP
OP
Pitalplace
Member
Thanks Allan
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy