(800) 853-2651
SHOP NOW

Belarus pto still slipping

B

boltcuter

New User
okay one more time I have a 925 Belarus that needs to have the pto adjusted.Where the 4 or 5 bolt cover under which the adjustment bits should be there is what I believe to be a draft and position control with a mixer control system.Does this make sense or have I been staring at the north end of a south bound roosky for to long?I do have a Belarus service manual but it is'nt all that usefull.
 
Standing at the back of the tractor,find the hyd.cyl. that raises and lowers the 3 point.It is directly under that.Between the fuel tanks.
 
in the manual it shows a picture of the cover being where you say it should be however under the ram is a large cover that runs from the side of the plate to just a little past center and is about 5 to 6 inches wide.
 
Not sure what that is,but there is a manual cyl lock on the cylinder which will hold the 3 pt. up.The best way to access that cover is to knock the pin out of the cyl. rod where it hooks to the 3pt rock shaft.Then retract your cyl. like your raising the 3 pt.Then take a block of wood and jam it in behind the cover under the cyl.This will hold the cyl. up out of the way so you can take the cover off.
 
hate to sound like a whinner but been there done that .pulled pin,angle cut a 2x4 wedged it in washed every thing out still no cover.another interesting point the manual shows the 2 adjustment rods to be on the control rod which would put them right where the large cover is
 
I think I know what you are telling us. Can you get the cover you see off and see what under it. I heard of a differant cover but have'nt seen it.
 
You must have a later model or something different than mine.Have an 825,have adjusted ours several times.Not a real big job.
 
You must log in or register to reply here.

Similar threads

D
Belarus 822 3-Point in Position Control
Replies
0
Views
60
datacommand
D
W
Draft control fork
2
Replies
22
Views
2K
JMOR
J
W
What specs do you use to set hydraulics on a Jubilee
2
Replies
23
Views
573
JMOR
J
C
MF20 Industrial - PTO Slipping
Replies
5
Views
383
Clarkbug
C
J
861stuck draft control lever
Replies
18
Views
690
jyergin
J
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top