(800) 853-2651
SHOP NOW

Ford 641 workmaster 3 point arms

A

Anonymous-0

Well-known Member
The 3 point arms on my tractor will not lift all the way to the top. They work well in the lower 2/3 range of motion. Just won"t go up to the upper 1/3 on the range of motion. Anyone have any ideas of what may be happening?
 
With the hyd lever all the way up, push the draught control lever down part way and see if the 3point raises all the way.
 
Thanks for the tip. That did work for the most part. The arms didn't come up all the way, but alot better than they were (90-95% up). The next question is how do I get it set to do it every time I rise the lift lever. I lowered the arms after rising them by your suggestion and they only came up about 2/3 the way again. Anymore help you could provide would be greatly appricative.
 
All my shop books are buried , If someone has the repair manual , It tells how to make an adjustment to get things working properly, if adjusting doesnt work, it may be a bad O ring?
 

Lift control lever starts working at 3/4 up position. Has power to lift equipment. Lately it,when dropped down,sometimes,does not raise back up until a couple of tries.(acts like cam not working all the time) Is this a simple fix? not sure what to do. Don't know if it's ready for rebuild. Fluid level ok.
 
You must log in or register to reply here.

Similar threads

P
Advice on 3 pt pallet fork
Replies
3
Views
278
old-9
O
S
John Deere 6603
Replies
1
Views
285
used red MN
U
R
Would you hazard a guess on a JD 3 pt system
Replies
4
Views
584
Tx Jim
Tx Jim
C
Belarus 400a 3 point issue
Replies
10
Views
221
RedWhiteandBluewoodlaunch
RedWhiteandBluewoodlaunch
W
link arms stuck
Replies
3
Views
424
RGMartin
R
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top