Brian Love
Member
thought you were just offering up sarcasm again sorry i took it wrong
- Thread starter Brian Love
- Start date
Brian Love
Member
thanks for the friendly reply again sorry bout my poor judgement
Janicholson
Well-known Member
I was also modestly humerous in my reply, No grief at all.
I recommended a low speed 3/4" electric drill with an adapter made to fit the grank snout. Putting a long pipe (About 5') into the threaded fitting as a ground contact to eliminate kickback grief. We often started our bailer with an old 1/2" Mall (brand) drill that is still operating. We used a 3' pipe, and rested it on the frame. Jim
I recommended a low speed 3/4" electric drill with an adapter made to fit the grank snout. Putting a long pipe (About 5') into the threaded fitting as a ground contact to eliminate kickback grief. We often started our bailer with an old 1/2" Mall (brand) drill that is still operating. We used a 3' pipe, and rested it on the frame. Jim
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy