I have a 1954 Ford NAA. The 3 point lift will not lift, on the right hand side, while sitting on the tractor, there is a hole with a shaft sticking out slightly there are threads in the tractor body. My friend thinks I am missing a cap with a bearing inside of it that holds that shaft which affects the lift from working. Does anyone know what I am talking about or what I need?
- Thread starter Mark Bei
- Start date
If you look at the threaded part you should see another piece threaded in there with a slot for a big screwdriver. That part is Hyd Lift back Valve assy (NAA 955E). You screw it in to put pressure from that valve/line to the internal cylinder. If is not tight or is missing the internal rubber o ring on the cylinder your 3 pt will not work. It is covered by a gasket and an accorn nut on the outside. Email if you need more info.
The picture helps. It sounded to me like you were missing the tach drive at the back of the pump, but the picture seems to show you are missing the blind nut that hold the hydraulic backpressure valve in place... Item # 32?
That's FAR out of may area of expertise. You'll find the NAA GURUS over at the Ford-specific Forum linked below.
<img src = "https://photos.yesterdaystractors.com/gallery/uptest/a5047.jpg">
<img src = "http://i167.photobucket.com/albums/u125/27Grainfield/NAAdiagram.jpg">
Ask HERE:
That's FAR out of may area of expertise. You'll find the NAA GURUS over at the Ford-specific Forum linked below.
<img src = "https://photos.yesterdaystractors.com/gallery/uptest/a5047.jpg">
<img src = "http://i167.photobucket.com/albums/u125/27Grainfield/NAAdiagram.jpg">
Ask HERE:
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy