LOU from WI
Member
With no equiptment to speak of. but a circular saw.press,mig welder. arc welder,limited hand tools and a whole lot of patience,it is more then possible to close in the floor so no wind, snow comes in to freeze the operator. Floor material is 16 guage with flanges that fit into
the existing floor plate.The battery is set into the panel on the right side.and will be herculined so the battery will not be able to rub on the panel,and no gas from the battery will destroy the panel. The panels are notched
to fit around the brake pedals and clutch. There will be 8"X16" boots over all the pedal arms.
Thought you folks would enjoy the pictures and
the 706 is comming together. More work tomorrow.
LOU
the existing floor plate.The battery is set into the panel on the right side.and will be herculined so the battery will not be able to rub on the panel,and no gas from the battery will destroy the panel. The panels are notched
to fit around the brake pedals and clutch. There will be 8"X16" boots over all the pedal arms.
Thought you folks would enjoy the pictures and
the 706 is comming together. More work tomorrow.
LOU