935 Versatile

Mr Versatile · Jun 18, 2009

Can not get the pins on steering cylinders out, they are loose and turn but won"t come out, seems there is a bushing. Is heat the answer?

nhboyd · Jun 18, 2009

I don't think you can get heat where you need it to be. I have used a jack to push them out.

Mr Versatile · Jun 18, 2009

Been there done that one already, but might try again,,,thanks

nhboyd · Jun 18, 2009

This a a little tough to do. Build a puller around the bracket the pin is in so you pull down when you put pressure with jack and not just lift tractor. You will have a pipe for pin to go in on top. When you get lots of pressure hit the top hard with sledge hammer. I hope you understand what I am tring to say. I know these pins can be hard to get out. I work for Versatile dealer.

Anonymous-0 · Jun 19, 2009

The pivot pins will get a notch wore in them, and you have to level up both halves of the tractor, and hold your tongue just right to get them lined up, and then an air hammer will usually knock them out, but if the hinge boxes are really worn, then you are better off blowing them out with a torch, and cutting off the boxes and replacing them.

The pins on the steering cylinders are just naturally a tight fit. I have went so far as to freeze the steering cylinder pins to be albe to start them into the yoke and bushing.

One of the many reasons I learned to HATE Versash!ts.

Mr Versatile · Jun 19, 2009

HH also said to do the same thing, and he is a good neighbor, and just sure he won't mind stopping by to help out a good ole boy,,lol thanks for the help

935 Versatile

Mr Versatile

New User

nhboyd

Member

Mr Versatile

New User

nhboyd

Member

Anonymous-0

Well-known Member

Mr Versatile

New User

Similar threads