Fixed yet another B issue

Lanse · May 22, 2009

The throwout bearing and the leaky oil pan. I split the tractor and did them both. R Aiken told me that if ya put the oil pan on, and then the front bracket, then that could cause a leak, so i put the front bracket on, and then did the oil pan. I used that form a gasket stuff, and i sure hope i did it right this time....
B splitting
<object width="660" height="525"><param name="movie" value="http://www.youtube.com/v/H_n8Ro7xM_s&hl=en&fs=1&color1=0xe1600f&color2=0xfebd01&border=1"></param><param name="allowFullScreen" value="true"></param><param name="allowscriptaccess" value="always"></param><embed src="http://www.youtube.com/v/H_n8Ro7xM_s&hl=en&fs=1&color1=0xe1600f&color2=0xfebd01&border=1" type="application/x-shockwave-flash" allowscriptaccess="always" allowfullscreen="true" width="660" height="525"></embed></object>

Rootsy · May 22, 2009

Little bit less subtle than I am use to but you're learning...

Nancy Howell · May 22, 2009

Good for you, Lanse. Enjoyed the video.

Dick L · May 22, 2009

Interesting Lanse, A little rough but working alone takes some outside the box tactics sometimes.

^D

I had an engine on the engine stand ready to put the pan on and I didn't knowing you were going to stop by. I had planed on showing you where you would get leaks if care was not taken. Richard had clued you in earlier in the day I guess. Good deal.

r aiken · May 22, 2009

Good work, that is the way I do it. R Aiken

Fixed yet another B issue

Lanse

Well-known Member

Rootsy

Member

Nancy Howell

Well-known Member

Dick L

Well-known Member

r aiken

Member

Similar threads