E.Frank H.
New User
I have a super m farmall and the brakes just don,t hold good. I have replaced the discs,have plenty of peddle, but still just not much stopping power. Any help or suggestions will be appreciated. Thanks, Frank
- Thread starter E.Frank H.
- Start date
glennster
Well-known Member
did you have the drums and expanders turned? if not, you may want to have that done. also check the actuator balls to be sure they are still smooth and round, no flat spots. and also check the ramps the the actuator balls ride in. they should also be smooth and free of any rust nicks or burrs. you can dress them with some emery cloth.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy