OT/ Replace heat guage on 1992 Accord

Mark FL · Mar 14, 2009

I need to take off the plastic cover over the speedometer and other guages to replace the heat guage. How does the cover come off? It extends on over the AC vents and down past the radio. I can see two screws above the guages and one inside the coin tray hole. Are there any others? Any help is appreciated. Thanks

Bob Collins · Mar 14, 2009

Been a while since I retired from Honda service dept., but I think you need to pop out the switches on the dash below the instrument pod, there may be a blank cover in one of the holes. Behind where the switches were are two screws that need to come out. With the steering wheel in lowest position, there is just enough room to pull the pod out far enough to disconnect several wire plugs, use care with these things. When you get the pod all free, find a clean soft space and start removing screws and pieces to separate the plastic lens from the circuit board. At this point it is all obvious but haste can cause a need for bad words. Hope this helps.

Hobo,NC · Mar 14, 2009

Couple of screws behind the radio

OT/ Replace heat guage on 1992 Accord

Mark FL

Member

Bob Collins

Well-known Member

Hobo,NC

Well-known Member

Similar threads