(800) 853-2651
SHOP NOW

update on motor/hydraulic pump

A

Anonymous-0

Well-known Member
well guys guess what i found. a double set of relays they are a 5 prong and plug into a block.they were kinda tucked away into a spot that was hard to see.the base is a double but all one piece and accepts 2 relays that plug in from the top.although they look pretty rough (a couple bare wires coming into it)coming out is 2 wires that are identical to the wires from the motor so i am sure this is what it is for.what function do these relays actually do? i will clean it up and see if i can repair the wires that plug in from the bottom side.if not i will have to order another one and ill bet its a pricey little booger.thanks for all your inputs RICK
 
The simple toggle switch shown here will do it rather directly. I like solutions that make reliability improve. If your hydro motor runs up with one polarity, and down with the other, this csn replace all the relays and costly wiring. The circuit breaker or fuse may be in it already. JimN
v6651.jpg
 
Does your "new" hyd dump pump have power up and use gravity down?
Whole 'nother hydraulic and electric issue, if so.
Run the motor (one way) to lift and activate a elec/hyd valve to bleed down?
 
You must log in or register to reply here.

Similar threads

D
Pump housing crack above test port
Replies
6
Views
425
Dave G9N
D
A
Update on Farmall 706 head gasket/head problem
Replies
16
Views
1K
DWF
DWF
Geo-TH,In
Update on my round 2 it experiment.
Replies
2
Views
323
Geo-TH,In
Geo-TH,In
super99
Back to trailer wiring
Replies
13
Views
2K
super99
super99
V
new owner of a 620, will try to update this as we go.
2 3 4
Replies
61
Views
3K
valiant8086
V
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top